solidus

英

美

网络  固相线; 固相線; 斜线; 苏勒德斯; 斜线分隔符号

化学

COCA.46938

英英释义

noun

• a punctuation mark (/) used to separate related items of information
  Synonym:slashvirgulediagonalstrokeseparatrix
• a gold coin of the Byzantine Empire
  Synonym:bezantbezzantbyzant

双语例句

• The increase of fluorine content might have resulted in the decrease of solidus temperature and benefited the evolution of magma and the formation of K feldspar and albite approximately with end member composition.
  较高的F含量使岩浆固相线温度大大降低，有利于岩浆分异演化并形成接近端员组分的钠长石和钾长石；
• The temperature at the bottom of the lithospheric mantle was higher than the wet solidus temperature of peridotite before the thickening of the lithosphere, and was affected by the thickening-related dehydration of amphibole and phlogopite.
  增厚前岩石圈地幔底部温度高于橄榄岩湿固相线温度，并受闪石和金云母高压脱水作用的影响。
• Semi-solid processing is a new method proceeding between solidus and liquidus over convertional casting and forging.
  半固态加工是在液固相区进行的一种新型加工方法。
• The solidus temperature of the cratonic lithospheric peridotite fell due to the long-term metasomatism of the mantle molten/ fluid bodies.
  古老岩石圈橄榄岩的固相线温度受地幔熔/流体的长期交代而降低。
• The generic name stems from the Latin solidus," whole," probably in allusion to the reported properties of the goldenrods to heal wounds.
  通用名称源于拉丁文固、“大局”的报道可能针对性能的黄花来疗伤。
• Regression Analysis and Measurement for the Coefficient of Thermal Expansion of Eutectic Al-base Alloys at Solidus
  共晶铝合金热膨胀系数的测定与回归分析
• From the experimental data, the pouring temperature, liquidus and solidus temperatures of the alloy are obtained, and the solidification range of the alloy is determined as 71 ℃.
  测试了合金的浇注温度，液相线温度和固相线温度，得出合金的凝固温度区间为71℃。
• On the Solidus of Primary Metallic Solid Solutions
  初级金属固溶体的固相线
• By XRD, SEM and DSC methods, the microstructure, element distributions and temperature of solidus and liquidus of Ni Cr B alloy ribbon were studied respectively.
  利用DSC，XRD和SEM等方法对急冷Ni-Cr-B合金箔带的固液相线的温度，结构及成分分布进行了研究。
• The results indicate that the welding temperature is the most important factor for diffusion welding of composite. When the welding temperature range is between solidus and liquidus, the peak joint strength can reach 170 MPa.
  指出焊接温度是复合材料扩散焊接最重要的工艺参数，焊接温度介于基体合金固相线与液相线之间，接头强度最高值可达到170MPa；